Analyses
Borowski Engineering is capable of performing many types of analysis from Linear Static and Dynamic Analyses to Multi-Physical Assessments (thermal fluids) and Event Simulation. Each of these analyses begins in a similar fashion.
It starts with a sketch or a photograph
Which is turned into a CAD model
Either 2D
or 3D
The model is then descretized using any variety of methods.
And then any series of analyses may be performed:
|
Linear static analysis is the
basis for many more complicated analyses and is acceptable for situations
in which loads do not result in stresses beyond the elastic region of the
material.
|
Motion and impact are two
purposes for conducting an event simulation. Unknown impact forces,
motion after impact, inertial load transfer, and wall interaction may also
be determined through this analytical technique.
|
|
| Dynamic Analysis is know by many names and each contains subtle differences in required inputs as well as analytical basis. |
Either transient or steady
state, this analysis can be used to determined temperature of a structure
during equipment start-up or during continuous operations.
|
|
|
Non-linear Analysis is
required under a few circumstances: Stresses approach or exceed the
yield strength of the material. Deflections become large relative to
the size of the modeled structure. The structure is expected to
buckle.
|
wFluids Steady and Unsteady Flow of viscous fluids around and/or through objects. It is also possible to simulate fans and other rotating equipment through revolving frames.
|
Borowski Engineering & Analytical Services,
Inc.
1420 Polaris Dr.
Mobile, AL 36693
251.232.3723
email: info@borowskiengineering.com